Skyline 32 Flight Controller + on board OSD to simplify your FPV build. No need for unreliable external OSD modules anymore. With a simple flick of a switch, the OSD can easily and quickly be turned ON or OFF. The OSD is integrated into the Flight Controller so setting up is simple.
Connect an fpv camera and Video Tx directly to the Skyline 32 + OSD board. With MW_OSD pre installed on the Skyline32+OSD, the pilot can change PID on the spot through OSD without having to connect to a computer. Simply use the transmitter’s stick commands and follow the OSD menu. Supports PPM signal via Channel 1 in RC_IN port (UART2), and supports SBUS signal via Channel 4 in RC_IN port (UART2).
The Skyline32 Advanced flight controller with its Cleanflight and Baseflight (NAZE32 firmware) support brings to you the innovation only available from the ever-growing Open Source community.
OSD......Virtually no set up
Preloaded MW_OSD firmware is tightly integrated with the rest of the flight controller
Using nothing but the transmitter and video goggles, the user can access:
-PID, RC rate, expo, Roll/Pitch/Yaw Rate, TPA
-Voltage alarm, voltage values and option to turn on/off voltage display
-RSSI monitoring and management
-With an optional current sensor, one can keep track of amp draw.
-With optional GPS module, one can check GPS coordinates, speed, distance, altitude (altitude read out available on Advanced version)
-Overall Timer, Flight timer, Flight statistics, etc.
**For more info regarding MW_OSD, check this website: http://www.mwosd.com/
***PLEASE BE SURE TO TURN OFF THE OSD WHEN MICRO-USB IS IN USE***
Run Cleanflight, Betaflight, or Baseflight
Wire-to-Board micro connectors.
Built-in gyro/accelerometer, magnetometer (Advanced Version also includes barometer and magnetometer)
Thin and ultra compact for clean/tight builds.
Uses top quality electronic components and high precision SMT.
32-bit ARM micro processor running at 3.3v / 72MHz.
Fly in Manual Mode, Angle Mode, Horizon Mode, Head-Holding Mode, Head-free Mode, and Altitude-Hold Mode (Altitude-Hold Mode is available in Advanced version).
Supports Quad-,Tri-,Hex, Octo-, various multirotors.
Flexible RC Input: PPM, Non-Inverted SBUS, PWM.
Flash to latest firmware through the Micro-USB (**NOTE: Please be sure to leave OSD switch OFF when using Micro-USB).
GPS Hold / Return-To-Home Feature supported (GPS module needed).
Dimension: 35mm x 35 mm x 5 mm (30.5mm Mounting)
Weight: 4.8g (W/O wires)
SKYLINE32 +OSD Advanced
2x RC breakout cable
1x vBat cable
1x buzzer cable
2x UART cables
4x Nylon Standoffs and nuts
1x Header Pin Assortment :Straight and 90 Degree
Note: SKYLINE32+OSD hardware is compatible with NAZE32 firmware, including cleanflight, baseflight. Below are the links to the source codes